Omron CK3E Series - Performing the Initial Settings for the PMAC

6
Enter the type of project for which
EtherNet/IP can be set, desired project
name, and the save destination, and
click the OK button.
3-3-2
Performing the Initial Settings for the PMAC
Perform the initial settings for the PMAC.
Precautions for Correct Use
Since all memory is cleared by the initial settings, be sure to save any data remaining in the
PMAC that you may need.
1
Execute the $$$*** command from the
T
erminal to set the PMAC to the factory
default state.
2
In the Solution Explorer, select System
– CPU – System.
3
Select Clock Settings.
3 EtherNet/IP Connection Procedures
3-14
CK3E/CK3M/CK5M Series EtherNet/IP Connection Guide (O903)