What to do for Omron CS CJ1W-ETN21 Network Hardware error code 03C4?
To resolve error code 03C4 on your Omron Network Hardware, you can either: * Correct the settings for each server. * Inspect the communications path (Ethernet Unit, cable connections, hub, router, server) and fix the cause of the error.
What to do for Omron Network Hardware error code 03C1?
To fix error code 03C1, set the server settings correctly based on the information provided in the detailed error code.
How to fix Omron CS CJ1W-ETN21 Network Hardware error code 021A?
To resolve error code 021A, recreate the data specified by the 2nd byte of the detailed error code.
How to resolve specified word or specified bit data area/ address error on Omron CS CJ1W-ETN21 Network Hardware?
To resolve errors related to specified word or bit data area/address, ensure that you correctly set the data area and address for the specified word or bit.
How to fix details of trigger setting error on Omron CS CJ1W-ETN21?
To correct trigger setting errors, ensure that you correctly set the trigger type setting.
What to do if Omron CS CJ1W-ETN21 shows lit RUN with flashing HOST indicator?
If the RUN indicator is lit and the HOST indicator is flashing, it indicates an error in the server settings (DNS, SMTP, or POP3) within the Unit Setup. Check the Error Status Flags and error log to identify and correct the problematic setting. If the error persists after correction, consider replacing the CPU Unit.
What to do if Omron Network Hardware shows not lit RUN and flashing HOST indicator?
If the RUN indicator is not lit and the HOST indicator is flashing, it could be due to: * An authentication error in 'POP before SMTP'. * A communications problem with the server. * A network failure causing an access timeout. To resolve this: * Verify and correct the POP settings (account and password). * Check the communications path (Ethernet Unit, cable connections, hub, router, and server) for any issues or damage.
General| Model | CJ1W-ETN21 |
|---|---|
| Category | Network Hardware |
| Manufacturer | Omron |
| Number of Ports | 1 |
| Communication Standard | Ethernet |
| Data Link Layer | IEEE 802.3 |
| Transmission Speed | 10/100 Mbps |
| Type | Ethernet Unit |
| Series | CJ Series |
| Compatible PLC Series | CJ Series |
| Communication Protocol | TCP/IP |
| Power Supply | 24 VDC |
| Weight | 0.15 kg |
| IP Address Setting | rotary switch or software |
Provides an overview of the Mail Send Function, its details, and comparison with earlier models.
Details specifications for destination addresses, subject, body, attached files, and mail triggers.
Guides users on performing the Mail Send Function, including setup and mail address configuration.
Introduces the Mail Receive Function, remote mail commands, and their specifications.
Details the procedure and required settings for using the Mail Receive Function.
Provides an overview of the FTP server function and its technical specifications.
Guides on using the FTP server, including procedures, settings, and available commands.
Details the procedure and settings required for automatic clock synchronization.
Explains socket basics, port numbers, and differences between TCP and UDP protocols.
Details socket service functions, how to use them with switches or CMND(490).
Illustrates TCP/IP and UDP/IP communications programming examples using CMND(490).
Introduces FINS communications over Ethernet, including FINS/UDP and FINS/TCP methods.
To Next Page