A Appendices
A - 52
E3NW-ECT EtherCAT Digital Sensor Communication Unit Operation Manual (E429)
A-2 Using Distributed Sensor Units
This section lists the models of Sensor Amplifiers that you can connect to the E3NW-DS.
The E9NC-TA0 is supported from E3NW-ECT Ver 1.03. The E3NX-CA0 is supported from E3NW-ECT Ver 1.06.
The E3NX-MA0, E2NC-EA□0, E9NC-AA□0/VA□0/VD□0 are supported from E3NW-ECT Ver 1.08 of the
E3NW-ECT.
You can check the version with object index 100A hex. (Refer to "A-1-4 Communication Objects" on page A-4.)
A-2-1 Models of Sensor Amplifiers That Can Be Connected to
Distributed Sensor Units
Name Model Features
Smart Fiber Amplifiers E3NX-FA□0 These standard fiber amplifiers are easy to use and set up.
Smart Laser Amplifier Unit E3NC-LA0
These laser sensors use a minute spot and yet they provide
stable detection.
Smart Laser Amplifier Unit
(CMOS Type)
E3NC-SA0
These laser sensors use a CMOS device that allows reliable
detection of stepped surfaces.
Contact-type Smart Sensors E9NC-TA0 These contact-type sensors are durable.
Color fiber amplifier E3NX-CA0 Fiber amplifier with color sensing for stable detection
Smart Fiber Amplifiers E3NX-MA0 Fiber Amplifier with Light Emission/Reception
Smart Fiber Amplifiers E3NX-FAH0 Fiber Amplifier with Near Infrared Light Emission/Reception
Smart Amplifier Separation
Proximity Unit
E2NC-EA□0 Proximity Sensor Amplifier
Smart Analog Input Unit E9NC-AA□0 Current (4 to 20 mA) Input Amplifier
Smart Analog Input Unit E9NC-VA□0 Voltage (1 to 5 V) Input Amplifier
Smart Analog Input Unit E9NC-VD□0 Voltage Differential Input (−2 to 2V), Input Type
To Next Page
Loading...
