Omron E3X-DA-N - Flashing Function; Display Orientation Setting; Display Hold Setting; Monitor Focus

A-429E3X-DA-N
E3X-DA-N
Characteristic data (default)
Connection
Connection with linear sensor controller K3NX-VD2#
Nomenclature:
amplifier units
Standard, monitor-output, mark-detecting, infrared, and
water-resistant models
Twin-output models
Hysteresis vs. sensing distance Repeated accuracy vs. sensing distance
Reflective model
Reflective model
E32-D11L
E32-DC200
Monitor output vs. distance
(In standard mode)
Through-beam
Reflective model
E32-TC200
E32-DC200
30
25
20
15
10
5
0
100 200 400300 500
Distance (mm)
Hysteresis (mm)
Super-
long-distance
Super-
high-speed
Standard
Sensing object: White paper
Distance Hysteresis
OFFON
100
90
80
70
60
50
40
30
20
10
0
20 40 8060 100
Distance (mm)
Repeat accuracy (mm)
Super-
long-distance
Standard
Sensing object: White paper
X
ON
Super-
high-
speed
6
5
4
3
2
1
0
50 100 150 250200 300
Distance (mm)
Monitor output (V)
6
5
4
3
2
1
0
10 3020 5040 60 9070 80 100
Distance (mm)
Monitor output (V)
0 V Blue
+ V Brown
Monitor output Orange
E3X-DA-N
12 to 24
VDC
12 VDC, 80 mA *
K3NX-VD2
#
123456789
10 11 12 13 14 15 16 17
* Use this service power supply for the Sensor with reference to
the power consumption of each Sensor.
Note: 1. Various I/O Units are available for the K3NX. Select an
appropriate output type depending on the application.
2. For details about the K3NX, refer to the K3NX Datasheet
(N084) or the K3NX Operation Manual (N90).
3. This wiring is for the K3NX, with DC power supply
specifications and the Monitor (Analog) Sensor with DC
power supply specifications. Check respective power
supply specifications before wiring them.
Level DisplayLock Button
Setting Buttons
TEACH
MODE
Operation Indicator (orange)
ON when output is ON.
OFF when output is OFF.
Operation Mode Selector
Use to switch between
Light ON and Dark ON modes.
Mode Selector
Use to select SET,
ADJ, or RUN mode.
Level DisplayLock Button
Setting Buttons
TEACH
MODE
Mode Selector
Use to select SET,
ADJ, or RUN mode.
Channel-selection Swit
c
Use to switch between
channel 1 and 2.
Operation Indicator (orange)
ON when output is ON.