To Next Page
M
Megan AndersonSep 23, 2025
How to check for programming errors in host device for Omron Temperature Controller?
- KKimberly CampbellSep 23, 2025
If there is a mistake in programming in the host device, use a line monitor to check the commands.
How to check for programming errors in host device for Omron Temperature Controller?
If there is a mistake in programming in the host device, use a line monitor to check the commands.
How to fix a large temperature error (S.Err display) on my Omron E5AC?
A large temperature error or an input error (S.Err display) on your Omron Temperature Controller can be caused by an input type mismatch. Check the sensor type and reset the input type correctly. It can also be caused by the thermometer not being installed properly. Check the thermometer installation location and polarity and install correctly.
How to prevent Omron E5AC Temperature Controller communication data corruption due to environmental noise?
If the communications data is being corrupted by noise, try using a slower baud rate. Also, separate the communications cable from the source of the noise.
Why can't I always change set points on my Omron E5AC Temperature Controller?
If it's sometimes not possible to change the set points or RUN/STOP status on your Omron Temperature Controller, there may be noise interference. Connect terminating resistance to both ends of the communications line.
How to stabilize Omron E5AC Temperature Controller communication line after power interruption?
If the communications line became unstable when the Controller’s power was turned ON or interrupted, initialize the reception buffer in the host device before sending the first command.
What to do if the host device sends another command before receiving a response from the Omron E5AC?
If the host device sent another command before receiving a response from the Controller, always read the response after sending a command.
How to set an end node for Omron E5AC communication line?
If an end node has not been set at each end of the communications line on your Omron Temperature Controller, set or connect terminating resistance at each end of the line.
What to do if the Omron E5AC isn't receiving the specified power supply voltage?
If the specified power supply voltage is not being supplied to the Controller, supply the specified power supply voltage.
What to do if the Omron E5AC communication cable is broken?
If the communications cable is broken on your Omron Temperature Controller, replace the cable.
What to do if the Omron E5AC communication line is disconnected?
If the communications line has become disconnected on your Omron Temperature Controller, connect the communications line securely and tighten the screws.
General| Mounting Type | Panel Mount |
|---|---|
| Sampling Period | 50 ms |
| Protection structure | IP66 (front panel) |
| Control Method | ON/OFF |
| Input Type | Thermocouple, RTD |
| Supply Voltage | 100 to 240 VAC |
| Output Type | Relay, Voltage, Current |
| Control Output | Relay, voltage, current |
| Dimensions | 96 x 96 mm |
| Display Type | LCD |
| Number of Displays | 2 |
| Alarm Output | Relay |
| Communication | RS-485 |
| Ambient Operating Temperature | -10 to 55°C |
| Ambient Operating Humidity | 25% to 85% RH |
