Omron E5CN Guide

onlinecomponents.com
E5CN
E5CN
Communications Setting Level
To select this level, press the key once for less than one
second in the initial setting level. When the communications
function is used, set the communications conditions in this level.
Communicating with a personal computer (host computer) allows
set points to be read and written, and manipulated variables to be
monitored.
Advanced Function Setting Level
To select this level, you must enter the password (“-169”) in the
initial setting level.
You can move only to the calibration level from this level.
This level is for setting the automatic return of display mode, MV
limiter, event input assignment, standby sequence, alarm
hysteresis, ST (self-tune) and to move to the user calibration
level.
Calibration Level
To select this level, you must enter the password (“1201”) in the
advanced function setting level. This level is for offsetting
deviation in the input circuit.
You cannot move to other levels by operating the keys on the
front panel from the calibration level. To cancel this level, turn the
power OFF then back ON again.

Omron E5CN Specifications

General

Communication	RS-485 (optional)
Mounting	Panel Mount
Control Method	ON/OFF
Input Type	Thermocouple, RTD
Supply Voltage	100 to 240 VAC
Output Type	Relay, Voltage (for driving SSR), Current
Display Type	7-segment LED
Size	48 x 48 mm
Control Output	Relay, Voltage (for driving SSR), Current
Alarm Output	1 or 2 outputs
Dimensions	48 x 48 x 78 mm
Ambient Operating Temperature	-10 to 55°C
Protection Rating	IP66