Omron E5CN Guide

onlinecomponents.com
E5CN
E5CN
Initial Setting Level
Input type
Scaling upper limit
Decimal point
Temperature unit
Set point upper limit
PID / ON/OFF
Standard/heating and cooling
ST
Control period (heat)
Alarm 1 type
Move to advanced function
setting level
Set the pulse
output cycle.
Direct/reverse operation
Alarm 2 type
Limit the set point.
Select the control system.
Self-tuning
Select the alarm
mode.
Control period (cool)
For analog input
(Input type: 16)
0- to 50-mVsetting
Number of displayed digits
 : °C
 : °F
 : ON/OFF control
 : PID control
 : Standard
 : Heating/cooling
 : Enabled
 : Disabled
 : Reverse
 : Direct
Set point lower limit
Scaling lower limit
Adjustment Level
Hysteresis (heat)
AT execute/cancel
Communications writing
Heater current
value monitor
HBA
function
Set point 0
Set point 1
Setpointsused
by multi-SP
Temperature input shift
1-point shift
2-point shift
Proportional band
PID settings
Cooling coefficient
Dead band
Usedinheating and
cooling control
Manual reset value
Auto-tuning
Heater burnout
detection
Set point 2
Set point 3
Lower-limit temperature
input shift value
Upper-limit temperature
input shift value
Derivative time
Integral time
Clear the offset during
stabilization of P or PD
control.
Set hysteresis.
P
I
D
Hysteresis (cool)
 : Enabled
 : Disabled

Omron E5CN Specifications

General

Communication	RS-485 (optional)
Mounting	Panel Mount
Control Method	ON/OFF
Input Type	Thermocouple, RTD
Supply Voltage	100 to 240 VAC
Output Type	Relay, Voltage (for driving SSR), Current
Display Type	7-segment LED
Size	48 x 48 mm
Control Output	Relay, Voltage (for driving SSR), Current
Alarm Output	1 or 2 outputs
Dimensions	48 x 48 x 78 mm
Ambient Operating Temperature	-10 to 55°C
Protection Rating	IP66