How to stabilize Omron Temperature Controller communication line after power interruption?
If the communications line became unstable when the Controller’s power was turned ON or interrupted, initialize the reception buffer in the host device before sending the first command.
How to prevent Omron Temperature Controller communication data corruption due to environmental noise?
If the communications data is being corrupted by noise, try using a slower baud rate. Also, separate the communications cable from the source of the noise.
Why can't I always change set points on my Omron E5DC-RX0ASM-015 Temperature Controller?
If it's sometimes not possible to change the set points or RUN/STOP status on your Omron Temperature Controller, there may be noise interference. Connect terminating resistance to both ends of the communications line.
Why aren't the set points or RUN/STOP status changing for slaves on my Omron Temperature Controller?
If the set points or the RUN/STOP status will not change for any of the slaves, check that: * The wiring to the master (i.e., the Controller with communications unit number 0) is not correct. * The communications settings in the master are not correct.
Why are communications not possible with my Omron Controller?
Communications issues with your Omron Controller may arise if a non-recommended adapter is being used. Ensure that the connected device is not faulty.
How to resolve duplicate unit number on Omron E5DC-RX0ASM-015 Temperature Controller communication line?
If the same unit number as the Controller is being used for another node on the same communications line, set each unit number for only one node.
What to do if the Interface Converter isn't receiving the specified power supply voltage for Omron Temperature Controller?
If the specified power supply voltage is not being supplied to an Interface Converter (e.g., the K3SC), supply the specified power supply voltage.
How to resolve unit number mismatch on Omron E5DC-RX0ASM-015 Temperature Controller?
If the unit number specified in the command frame is different from the unit number set for the Controller, use the same unit number.
What type of communication cable should I use for Omron E5DC-RX0ASM-015?
If the wrong communications cable has been used for your Omron Temperature Controller, use shielded twisted-pair cable for the communications cable.
How to synchronize baud rate and communication method on Omron E5DC-RX0ASM-015?
If the same baud rate and communications method are not being used by all of the Controllers, host devices, and other nodes on the same communications line, set the same values for the following on all nodes: baud rate, protocol, data length, stop bits, and parity.
General| Type | Digital Temperature Controller |
|---|---|
| Model | E5DC-RX0ASM-015 |
| Display Type | LCD |
| Power Supply | 100 to 240 VAC |
| Mounting Type | Panel Mount |
| Communication | RS-485 |
| Output Type | Relay |
| Auxiliary outputs | 2 |
| Number of Control Outputs | 1 |
| Ambient Operating Temperature | -10 to 55 °C |
| Input Type | Thermocouple, RTD |
| Control Output | Relay |
| Control Method | PID |
| Size | 48 x 96 mm |
| Ambient Operating Humidity | 25 to 85%RH |
To Next Page
