Omron E5DC User Manual

6 Parameters
6 - 54
E5@C Digital Temperature Controllers User’s Manual (H174)
tr-t
Transfer Output Type
There must be a transfer output.
• This parameter sets the transfer output type.
*1 The remote SP will be output while the SP Mode parameter is set to the Remote SP Mode.
*2 This function can be set for a Position-proportional Model, but the setting will be disabled.
*3 This function can be set for standard control or for a Position-proportional Model, but the setting
will be disabled.
*4 This setting is displayed only for a Position-proportional Model.
 Related Parameter
Transfer Output Upper Limit and Transfer Output Lower Limit (Initial Setting Level): Page
6-55
000
Function
Setting
Transfer output type Default
OFF off off
Set point
*1
sp
Set point during SP ramp sp-m
PV pV
MV (heating)
*2
mV
MV (cooling)
*3
c-mV
Valve opening
*4
v-m
See
See

Omron E5DC Specifications

General

Brand	Omron
Model	E5DC
Category	Temperature Controller
Language	English