Omron E8F - Page 3

E8F
E8F
3
Note: 1. Negative-pressure model
2. Refer to the following for the operation modes available
at the time of initial settings.
Hysteresis Mode
Pressure valve
OFF set value ON set value
Output
0.98Mp
a
98 kP
a
–101 kP
a
10 kgf/cm
2
1kgf/cm
2
–76cmHg
In the above, the ON point is set larger than the OFF
point.
Wind Mode
Pressure valve
ON set value OFF set value
Output
0.98Mp
a
98 kP
a
–101 kP
a
10 kgf/cm
2
1kgf/cm
2
–76cmHg
In the above, the ON point is set smaller than the OFF
point.
3. The 2
1
/
2
-digit display refers to a display in which the
third
digit displays only 0 or 1.
0 or 1 0 to 9 0 to 9
Third digit
Second digit First digit
Characteristics
Voltage influence ± 1.5% FS max.
T emperature influence ± 3% FS max.
Degree of protection IEC IP66
Dielectric strength 1,000 V AC for 1 min
Insulation resistance 100 M Ω min. (at 500 VDC) between current carry parts and case
V ibration resistance Destruction: 10 to 500 Hz, 1.5-mm double amplitude or 100 m/s
2
(approx. 10G) for 2 hours
each in X, Y , and Z directions
Shock resistance Destruction: 500 m/s
2
(approx. 50G) 2 times each in X, Y , and Z directions.
Pressure port R(PT) 1/8 taper screw and M5 x P0.8 female screw for zinc die-cast pressure port
Cord 2-m-long UL-approved cord
Weight 60 g (excluding cord)