• Do not install in this orientation.
DIN Track
Set DIN rail to the bottom of the Sensor Controller. Set DIN rail on the top of the Sensor Controller.
Set DIN rail vertically to the Sensor Controller. Set DIN rail horizontally to the Sensor Controller.
DIN Track
• When mounting the Sensor Controller to the DIN rail, click the rail stoppers, hook the part of A to
rail one to the end, and then push up the rail stoppers with pushing to B direction.
• When removing, insert a flat-head screwdriver to the part of C and pull off.
5 Setup and Wiring
5-38
FH Series Vision System Hardware Setup Manual (Z366-E1)
To Next Page
Loading...