CSM_FQ2_DS_E_11_4
1
All in one Vision Sensor Smart Camera
FQ2 Series
Smart Cameras:
The New Standard for Image
Inspections
• All in one Vision Sensor
• Expanded performance and functionality
• A Lineup that fits a wide range of equipment
System Configuration
Be sure to read “Safety Precautions” on
page 9.
For the most recent information on models that have been certified for
safety standards, refer to your OMRON website.
FQ2-S1 FQ2-S2
FQ2-S3 FQ2-S4
Note: If you register as a member after purchasing a Sensor, you can download free setup software TouchFinder for PC that runs on a PC and
can be used in place of Touch Finder.
Refer to the member registration sheet for details.
Up to 32 Sensors can be set up and monitored from a single Touch Finder or TouchFinder for PC.
Various types of Sensors can be used at the same time.
However, I/O type and wiring method vary depending on the Sensor, so select the necessary devices.
Ethernet (EtherNet/IP, No-protocol, or PLC Link) Connection
I/O Cable
FQ-WD
Sensor
FQ2-S1/S2/S3/S4
I/O control PLCTrigger sensor
FL-STC
Lighting Controller
FL-series
External Lighting
Touch Finder
FQ2-D
or TouchFinder for PC
* RJ-45 of the FCC regulations
Standard
Ethernet Cable
*
FQ
Ethernet Cable
FQ-WN
Standard Ethernet Cable
*
Control PLC
Switching Hub
W4S1
DC24V
DC24V
Special Ethernet Cable
FQ-WN
Sensors (32 max.)*
FQ2-S1/S2/S3/S4
Switching Hub
W4S1
Touch Finder FQ2-D
or TouchFinder for PC
Standard Ethernet Cable
RJ-45 of the FCC regulations
*The Setup Tool can connect to up to 32 Sensors and it can display up to eight Sensors at the same time.
To Next Page
Need help?
General
