Omron FZ3 Series - Faq; During Start-Up; During Operation

8
Appendixes
FZ3 User's Manual FAQ 259
FAQ
During Start-up
POWER LED not lit
●
Is the power supply connected correctly?
●
Is the supply voltage low (24 V DC +10%,-15%)?
Nothing is displayed on the monitor
●
Is the monitor ON?
●
Is the monitor cable connected correctly?
●
Is the monitor malfunctioning?
●
Is the power capacity sufficient (LCD monitor)?
●
Have you turned off the LCD? If you have, monitor recovery will occur if you tap on the bottom of
the monitor.
Disordered monitor images
●
Are the power supply and cable generating electronic noise?
●
Is the monitor cable connected correctly?
Cannot input
●
Are the cables for input devices (mouse, etc.) connected correctly?
●
Is the angle too big when tapping is done with the touch pen?
Camera image does not display/Image is blurry
●
Is the lens cap removed?
●
Is the camera cable connected correctly?
●
Is the lens aperture at the maximum or the minimum?
●
Is the camera's shutter speed correct?
●
Is the lighting method correct?
During Operation
Measurement results do not display on the monitor
●
Are windows other than the Main screen (the Edit Flow window, etc.) displayed?
●
Are there any setting windows open?
* A setting window is defined as a window that opens separately such as the Edit Flow window
and the Scene Maintenance window.
The touch screen responds slowly
●
Are you tapping the touch screen continuously and quickly? If yes, the response to operation
may be delayed.
Acesst 1.0 6251194