Up/Down Counting Meter
K3NC
C-151
Counters
//
1200/2400/4800/
9600 /19200/38400bps
u-d b
/u-d c
0
/
count
u-d c
−−
−
−
−
−
−
−
−
−
−
Prescale value
bank
Decimal point
Input mode
Parity bits
Input A prescale
value mantissa
Input A prescale
value exponent
Communications
unit number
Baud rate
Word bit length
Stop bits
Sensor type
Power failure
memory
Output mode
Compensation
value
7 /8bit
1/ 2 bit
· In the Setting Mode, the measurement value is reset (i.e., to
0) and outputs turn OFF.
· Depending on the output type of the model used, some
parameters (indicated in ) are not displayed (and
hence cannot be set).
· If the input mode is changed, all parameters will be reset to
their initial values. Set the input mode first.
Protect Mode
Prescaling menu
1 s
Setup menu
1 s
No key operation for 5 s
Remote/local
programming
Changing Set Values
By pressing the Shift Key while a parameter is displayed, the set value can be
changed (setting status). The PROG status indicator will flash. Change the set
value as required, and press the Mode Key to register the setting and move to
the next parameter.
Setting Status
Next parameter
If there is no key operation for 5 seconds,
the setting is registered and the parameter
is displayed again.
PROG flashes.
Change the set value using the Up
Key and the Shift Key .
Settings displayed in reverse colors are defaults.
Option menu
No key operation for 5 s
No key operation for 5 s
No key operation for 5 s
No key operation for 5 s
No key operation for 5 s
No key operation for 5 s
No key operation for 5 s
No key operation for 5 s
No key operation for 5 s
(See note 1.)
(See note 1.)
(See note 1.)
No key operation for 5 s
1 s
No key operation for 5 s
No key operation for 5 s
No key operation for 5 s
No key operation for 5 s
No key operation for 5 s
Note 1: A number in the range 1 to 4 will be displayed.
· The measurement value will be reset if the Setting Mode is
entered during measurement.
Conditions that
allow compensa-
tion input
Upper limit (H)
of linear out-
put range
Lower limit (L)
of linear out-
put range
To Next Page
Loading...
