C-152
Up/Down Counting Meter
K3NC
Note:
If there is no key operation for 5 seconds, the setting is automatically registered.
prot
all
sUset
mm.rst
secr
prot
all
sUset
mm.rst
secr
kpon
kpoff
Protect Mode
Press the ESC Key
and Up Key for 1 s.
• Measurement stops in Protect Mode.
• Depending on the output type of the model used, some parameters (indicated in ) are not
displayed (and hence cannot be set).
Protect menu
Press the Mode
Key for 1 s.
All key protection
Set value change
prohibition
Maximum/minimum
value reset prohibition
Menus protected
in Setting Mode
(See
note.)
Displayed only for
models with
comparative outputs.
Note: Press the Shift Key to make it
possible to set or change parameters.
Power ON
RUN Mode
Key-protection ON:
Key-protection OFF:
Menu display Parameter display Meaning of parameter Setting range Setting key
(See note.)
All key protection:
All key operations are prohibited in
RUN Mode. (If all key protection is
ON, only the key for going to Protect
Mode is enabled.)
Use the Up Key to
change the setting.
Use the Mode Key
to enable the set-
ting and move to the
next parameter.
Set value change prohibition:
Changes to comparative set values
are prohibited in RUN Mode. (Dis-
played only for models with compara-
tive outputs.)
Reset prohibition:
Resetting the counting value using
the front panel keys is prohibited.
(Resetting by external signals is not
prohibited.)
Menus protected in Setting Mode:
Setting operations in Setting Mode
are prohibited in the way shown be-
low.
Use the Up Key to
change the setting.
Use the Mode Key
to enable the set-
ting and move to the
next parameter.
Setting menu Setting
012
Set value menu
×
Scaling menu
×
Setup menu
××
Option menu
×
prot
all
sUset
reset
prot
all
sUset
secr
secr
Setting:
Next parameter:
Press the ESC Key
to return to the menu.
Press the Mode Key
to display the parameter.
Setting:
Next parameter:
Setting:
Next parameter:
Setting:
Next parameter:
kpon
kpoff
Key protection ON:
Key protection OFF:
kpon kpoff
➤
➤
0
/1/2
1 2 3
➤
➤
➤
To Next Page
Loading...
