Omron H7EC - Page 72

C-78
Preset Counter/Timer
H8GN
■
Parameters
+
+
: N
: F
: C*
: K*
: A*
: B*
: D
: E
: F
: Z
Counting
speed
: 30 Hz
: 5 kHz
: 20 ms
: 1 ms
: 0
: 0.0
: 0.00
: 0.000
Power ON
Operation level
Protect level
Keys 1 s. min.
Advanced function setting level
: 3 to 30 s.
Key 1 s. min.
Initial setting level
Key 1 s. min.
Key 3 s. min.
Key 1 s. min.
Operation level
Key less than 1s.
Power ON
PV/SV
PV
SV-bank
See note 1.
See note 2.
See note 3.
Move to advanced function setting level.
Counter
Timer
: 0.01 to 99.99 s
: 0.00 to 99.99 s
: 0.001 to 9.999
Adjustment
level
Key
less than 1 s.
Key
1 s. min.
Key
3 s. min.
Initial
setting
level
Key
less than 1 s.
Communications
setting level
Key
1 s. min.
Password input
set value "−169"
Advanced
function setting
level
Operation in progress
Operation stopped
No display due to model and settings
No display due to model and settings
Level change
Keys
3 s. min. (default value)
Press the Key to
reset the PV.
Press the Key to reset
the totalizing count value and
the PV simultaneously
Totalizing
count value
When
totalizing
counter
selected
When
using
SV-bank
: SV 0
: SV 1
: SV 2
: SV 3
Parameter
initialization
Use SV-
bank
Use
totalizing
counter
Display
auto-return
time
Move-to-
protect-
level time
When
counter
selected
: Initialize
: Not initialize
: Use
: Not use
: Use
: Not use
: No auto-return
: 1 to 99 s.
Note : The parameters shown in reverse video are
the default settings.
Password input
(−169) and move
Counter/
Timer
selection
: Counter
: Timer
When
counter
selected
Input
mode
: Increment
: Decrement
: Individual
: Quadrature
When
timer
selected
Time
range
Timer
mode
: Elapsed time
: Remaining time
When
counter
selected
Output
mode for
counter
When
timer
selected
Output
mode for
timer
When the
above C*,
K*, A*, or
B* mode
selected
Output
time
Output will be held if output time is 0.
Output time cannot be set to 0 when
counter function is selected.
When
counter
selected
Input signal
width (start,
reset, gate)
When
counter
selected
Decimal
point
position
Prescale
value
: Counting on rising edge
: Counting on falling edge
When
increment
or
decrement
selected in
counter
input mode
Input
signal
edge