18
SETTING THE TruRead™ FUNCTION
The TruRead™ Mode takes three consecutive measurements. The
monitor will inflate, take a measurement, and deflate three times
separated by a short interval of time between each measurement.
Note: The default setting is OFF, which means the monitor is set to the
Single Mode to take one measurement.
When the TruRead is set to ON, the INTERVAL TIME can be set to 15,
30, 60 or 120 seconds.
Note: When the Automatic Memory Function is set to OFF, the
TruRead™ function can not be set to ON.
1. TO CHANGE THE SETTING
Press the START/STOP button
to turn the power off, then press
the SET button.
Press the SET button again.
The TruRead Screen is displayed with the
current setting.
The TruRead is set to OFF at the time of purchase.
2. SELECTING ON OR OFF
Press the ( ) button to change the TruRead
setting to OFF.
Press the ( ) button to change the TruRead
setting to ON.
TruRead Screen
TruRead ON Screen
To Next Page
Loading...
