Omron HEM-7280T-E - 3.3 Taking a Measurement

3. Using the Device
14
3.3 Taking a Measurement
Check if the date and time are correct on the display before taking the measurement. If the date
and time settings are necessary, refer to “Setting the Date and Time Manually” (page 10).
Notes:
• To stop a measurement, press the START/STOP button once to deflate the arm cuff.
• Remain still and quiet while taking a measurement.
The monitor is designed to take measurements and store the measurement values in
the memory for 2 people using USER ID 1 and USER ID 2.
1. Select your USER ID (1 or 2).
Push the switch up or down to select USER ID.
2. Press the START/STOP button.
The arm cuff starts to inflate automatically.
START
INFLATE
DEFLATE
COMPLETE
Cuff Wrap Guide Symbol
If your systolic pressure is
more than 210 mmHg
After the arm cuff starts to inflate, press and
hold the START/STOP button until the
monitor inflates 30 to 40 mmHg higher than
your expected systolic pressure.
Notes:
• The monitor will not inflate above 299 mmHg.
Inflating to a higher pressure than
necessary may result in bruising where
the arm cuff is applied.