36
6. Other Settings
5. Press [START/STOP] button to turn your
monitor off.
• All readings will be deleted. You cannot partially delete the
readings stored in the memory.
• Your monitor automatically turns off after 2 minutes.
6.2 Restoring Your Monitor to the Default Settings
To delete all the information stored in your monitor, follow the
instructions below. Make sure that your monitor is turned off.
1. While holding the button (rear surface of the
monitor) down, press and hold the [START/
STOP] button for more than 3 seconds.
The display to the right flashes.
2. While holding the button down, press and
hold the [START/STOP] button for more than 3
seconds.
The display stops flashing, then your monitor is restored to
the default settings.
To Next Page
Loading...
Need help?
General
