3
EN
1. Know Your Scale
2. Inserting and Replacing the Batteries
Batteries are already installed in the scale. To start using the scale, pull out the red film.
1. Open the battery cover on the back of
the scale.
2. Install the batteries in correct polarity
as + ends up.
3. Close the battery cover.
Battery Life and Replacement
When appears, replace both batteries with
new ones.
• Disposal of used batteries should be carried out
in accordance with the national regulations for
the disposal of batteries.
• Two CR2032 batteries will last approximately 1
year (when measurements are made three
times a day).
• Because the supplied batteries are for trial use
only, they may have a shorter life.
Operating instructions
To Next Page
Loading...
Need help?
General