13
2.Preparation
EN
2.3 Adjusting the Settings Modes
You can modify the options for the various settings of your unit.
This is done by pressing the SET button to select a setting,
then pressing the MEMORY button to select the options for that
setting. After selecting a setting, press the I/O button to confirm
the setting and turn the power off.
Buzzer Mode
When Buzzer mode is on, the unit emits sounds, during
measurement (to indicate that pulse waves are detected), and
when measurement is complete.
1. Press the SET button once
while the unit is in standby
mode.
The buzzer symbol
appears on the display.
2. Press the MEMORY button to select
“on” or “off”.
The setting alternates between “on”
and “off” with each press of the
MEMORY button.
The default setting is “on”.
3. When you have selected the desired setting, press the I/O
button to turn the unit off.
Notes:
• If you want to adjust the date or time, press the SET button
after setting the buzzer setting, follow steps for setting date
and time (Refer to 2.2) press the I/O button to turn the unit off.
• If you forget to turn the unit off, it will automatically shut itself
off after five minutes.
To Next Page
Loading...
Need help?
General
