3. Using the Unit
10
3.2
Using the Memory Function
This unit automatically stores the last 25 measurement results (excluding Hi/Lo results).
Notes:
• If the memory is full, the unit will delete the oldest reading.
• When the unit is switched between °C and °F, all the readings stored in the memory are deleted.
1. Press the ON/MEM button to turn on the unit.
2. Press the ON/MEM button again.
The memory number appears on the display.
3. Release the ON/MEM button.
The most recent result appears on the display.
Press the ON/MEM button repeatedly to view the older results.
4. Press and hold the ON/MEM button until "OFF" appears on the display to
turn off the unit.
The unit turns off with the room temperature on the display.
MC-720-AP_A_M.book Page 10 Friday, May 22, 2015 11:01 AM
To Next Page
Loading...
