Omron NX1 Series User Manual

2
Server Function
This section describes a function that issues FINS commands supported by the NX-
series CPU Unit and, reads and writes the memory used for CJ-series Units.
2-1 Overview of Server Function
........................................................................ 2-2
2-2 FINS Commands Supported by NX-series CPU Units ................................ 2-3
2-3 Setting of FINS Node Address of Built-in EtherNet/IP Port........................ 2-5
2-4 FINS Routing Table Setting ........................................................................... 2-7
2-5 FINS Write Protection Function .................................................................... 2-8
2-6 FINS Command Execution Condition........................................................... 2-9
2-7 TCP/UDP Port Close Function .................................................................... 2-10
2-1
NX-series CPU Unit FINS Function User's Manual (W596)
2

Omron NX1 Series Specifications

General

Brand	Omron
Model	NX1 Series
Category	Controller
Language	English