Omron Sti F3SJ-B P25-02TS Series - 6-5. Mounting and Beam Alignment

7
F3SJ-B-02TS
Quick Installation Manual
■Dimensions (Check position)
M3 x 6 screw
M3 x 6 screw
Top/Bottom
Bracket
(F39-LJB1)
Top/Bottom
Bracket
(F39-LJB1)
Intermediate
Bracket
(F39-LJB2)
C (Protective height)
<M5 screw fixed> <M8 screw fixed>
19
B B
E
C C
E
42
42
5.9 5.9
22 22
4-M5
2-M8
2-M5 2-M5
D
A
22.5 34.5
19
42
22
13.3
2
13.4
5.9
B
E
30
6.5
53
5.5
dia.9
17
35
47
47.8
33.6
[ Unit : mm ]
[Side mounting]
If the protective height exceeds 545 mm, use the intermediate brackets as many as and on the positions specified in the
dimensional drawing. Otherwise ratings/specifications cannot be satisfied.
If load is applied to the sensor unit in your environment, add intermediate bracket(s).
For mounting brackets other than top/bottom brackets (F39-LJB1) and intermediate brackets (F39-LJB2) as well as external
dimensions, refer to F3SJ-B-02TS series user's manual.
Dimensions A to E
Dimensions E
* Value E must be 530 mm or less when not using value E obtained from the calculation above.
AC+69
BC+42.2
C 4-digit number of the type name (protective height)
DC-45
E Depends on the protective height. See the table below.
Protective height Number of Intermediate Brackets Dimensions E
0225 to 0545 0 -
0625 to 1105 1 B/2
1185 to 1585 2 B/3
1665 to 1985 3 B/4
Check
position
Step1
Mount
Step2
Align
beams
Step3
Mounting/Beam Alignment
Wiring
Function Selection
Pre-Operation Checklist /
Maintenance Checklists