13
After LightBurn finishes installing its connection to your engraver’s new control card, go to the Edit menu and
select Device Setting. Under the Basic Settings tab, find the Other Options section and activate Enable Smoothie
Clustering.
3.7 Testing
Restore power to your engraver and test that all of its safety features remain fully functioning. Test that the control
panel and control computer are able to move the engraver’s laser head and fire the laser correctly. Correct any
problems before further use, making sure to fully disconnect the engraver from its power supply before making any
adjustments. Contact technical support or customer service if any problems remain or arise after installation.
To Next Page
Loading...