Electric
Start
Models
1.
Open the fuel valve (Figure
3-2).
2.
Check to be sure that the speed control fever
is
in
the high speed
(“HI’)
position (Figure 3-3).
3. Set the choke lever to the CLOSE position (Figure
3-4).
If
engine is warm from previous operation, do
not close the choke.
4. Start the engine by pressing the Start/On/Stop
switch
to
the START position. Release switch when
engine starts and it will return to the On position.
Open the choke lever as the engine warms up.
Allow theenginetowarm up forthreetofive minutes
before applying a load. The voltmeter on the control
panel will indicate generator output voltage.
If
the oil watch lamp flashes during cranking orrunning, stopthe
engine and check the
oil
level. Add
oil
as
recommended in the
Maintenance
section.
5.
Proceed to Adding Loads in this section.
Manual
Start
Models
1.
Open the fuel valve (Figure 3-2).
2.
Check
to
be sure that the speed control lever is in
the high speed
(“H)
position (Figure
3-3).
3.
Set the choke lever
to
the CLOSE position (Figure
3-4). If engine is warm from previous operation, do
.
not close the choke.
4. Make sure the engine switch is in the On position.
5.
With one hand on the generator set to steady
it,
grip
the recoil handle and pull out smoothly and quickly.
Repeat as necessary. When the engine
starts,
open
the choke lever as the engine warms up. Allow the
engine to warm up
for
three to five minutes before
applying a load.
lftheoil watch
lampflashesduringcranking
orrunning,stopthe
engine and check the oil level. Add oil as recommended in
the
Maintenance section.
6.
Proceed to Adding Loads in this section.
1.4
EGSAA
M-1841-1
1.7
-
4.0
EGH
&I842
5.0
-
6.0
EGH
FIGURE
3-4.
CHOKE
LEVER
3-5
To Next Page
Loading...
