Setting Up Your Satellite Receiver or
Cable Converter
To set up the ONE FOR ALL 4 for your Satellite Receiver
or Cable Converter:
Find your Satellite Receiver
code in the Set-Up Code
section (starting on page 23).
To set up your Cable
Converter follow the
instructions below, but use
the cable converter codes.
Codes are listed by brand
name. The most popular code
is listed first. Make sure your
Satellite Receiver (or Cable
Converter) is switched on.
Press and release the ONE
FOR ALL 4’s
SAT key, then
press and hold down the
MAGIC key
until the red
light blinks once and then
twice.
Enter your
three-digit
Satellite (or Cable) code
using the number keys. The
red light will blink twice.
Now, aim the ONE FOR
ALL 4 at your Satellite
Receiver (or Cable
Converter) and press
POWER. If your Satellite
(Cable Converter) switches
off, your ONE FOR ALL 4 is
ready to run your Satellite
Receiver (Cable Converter).
Write your code in the three boxes on page 22, for easy
future reference.
To control your Satellite Receiver or Cable Converter,
press SAT first.
If your Satellite Receiver or Cable Converter does not
respond, follow steps 1 through 4 with each code listed for
your brand. If none of the codes listed for your brand
operate your Satellite or Cable Converter, then try the
search method described on page 11, even if your brand is
not listed at all.
■ ■ ■ ■
■ ■ ■ ■
9
1
2
3
4
To Next Page
Loading...
Need help?
General
