SEARCHING FOR YOUR CODE
If your device does not respond to the URC-8910 remote control
after trying all codes listed for your brand, or if your brand is not
listed at all, try manually searching for your code.
For example, to manually search for a code for your TV:
1. Turn on the TV.
2. On the URC-8910 remote control, press and hold
SET until you see the display change from the
current device and time to [CODE SET].
NOTE: The device, its code, and time are examples.Your
remote control settings may be different.
NOTE: To exit programming at any time, press EXIT once or
allow 30 seconds of inactivity to lapse.You will see [EXIT
SETUP] as the remote control returns to normal operation.
NOTE: [INVALID] means you have inadvertently pressed an
incorrect key. Note your error and continue programming.
3. Press the ▼ key once until you see the display
change to [MAN SEARCH].
NOTE: If you go past [MAN SEARCH],press the
▲
key one or
more times to return to it.
4. Press SELECT once to begin programming.You will
see the display change to the last-selected device
and its code (e.g.,VCR and 0035).
5. Press a desired device key once (e.g., TV).You will
see the display change to the desired device and the
first code in the manual search list (e.g., TV and
0047).
6. Aim the URC-8910 remote control at the device
(e.g., TV)and press SELECT once.You will see the
LED (red light) blink and the (IR) icon flash
indicating IR codes are being transmitted.
continued on next page...
14
To Next Page
Loading...
Need help?
General
