USING MACROS
With programming, the M1 through M3 keys on your URC-8910
remote control can be setup to perform repetitive, time-consuming
operations for easy, convenient access through the press of a single
key. Macro keys are ideal for home theater operations, setting a
favorite channel, guide steps,or other multiple functions you would
like to control with one key press. Moreover, each macro key can
hold up to15 key presses total.
NOTE: Programming a new macro over an existing one will erase the
original macro.
Programming A Favorite Channel
With so many channels available through your cable or satellite
system provider, you can program a macro that directly selects a
favorite channel with one key press. For example, let’s assume your
favorite cable programs are on channel 71. Perform the following
steps to program a macro key for direct access of this channel:
NOTE: This example assumes the TV tuner is connected directly to the cable
line and not through a cable converter.
1. On the URC-8910 remote control, press and hold
SET until you see the display change from the cur-
rent device and time to [CODE SET].
NOTE: The device, its code, and time are examples.Your
remote control settings may be different.
NOTE: To exit programming at any time, press EXIT once or
allow 30 seconds of inactivity to lapse.You will see [EXIT
SETUP] as the remote control returns to normal operation.
NOTE: [INVALID] means you have inadvertently pressed an
incorrect key. Note your error and continue programming.
2. (x 6) Press the ▼ key six times until you see the display
change to [KEY MACRO].
NOTE: If you go past [KEY MACRO],press the
▲
key one or
more times to return to it.
3. Press SELECT once to begin programming.You will
see the display change to [SEL MACKEY].
4. Select an open macro key (e.g., M1) and press it
once.You will see the display change to [ENTER SEQ].
21
To Next Page
Loading...
