INSTALLING BATTERIES
1. On the back of the URC-8910 remote control, push
the tab and lift off the battery cover.
2. Obtain four (4) new AAA alkaline batteries. Match
the + and – marks on the batteries to the + and –
marks in the case, and then insert the new batteries.
3. Align the cover key with the case opening and
replace the cover until it locks.
4. If batteries are inserted correctly, the entire LCD
will turn on.After 5 seconds of inactivity, the remote
control will turn itself off to conserve battery life.
5. Perform the steps in Setting The Clock (on the next
page) to set the correct time.
NOTE: When a battery icon appears in the display (see page 7, Key Charts,
LCD), the batteries are low. Simply replace them and the URC-8910 remote
control will be restored to full functionality, complete with your favorite settings.
4
To Next Page
Loading...
Need help?
General
