Programming Volume Unlock
1. On the URC-8910 remote control, press and hold
SET until you see the display change from the
current device and time to [CODE SET].
2. (x 5) Press the
▼ key five times until you see the display
change to [VOL UNLOCK].
NOTE: If you go past [VOL UNLOCK],press the
▲
key one or
more times to return to it.
3. Press SELECT once to begin programming.You will
see the display change to [ALL MODE].
To unlock one mode, skip to step 4. Otherwise press
SELECT once to unlock all modes.You will see the
display change to [UNLOCKED] and then [EXIT SETUP]
as the remote control automatically exits the pro-
gramming mode and returns to normal operation.
4. or (Optional) Press ▲ (or ▼) once.You will see the
display change to [ONE MODE].
a. Press SELECT once.You will see the display change
to [SEL MODE].
b. Press a mode key once (e.g., TV) to unlock it.
You will see the display change to [UNLOCKED]
and return to [SEL MODE].
c. If desired, repeat step 4b as needed to unlock
volume controls for other devices.Otherwise,
press EXIT to exit the programming mode.You
will see an [EXIT SETUP] message as the remote
control returns to normal operation.
20
To Next Page
Loading...
