USING KEYMOVER
Restoring Keymoved Keys to Default Settings
Restoring A Single Keymoved Key (continued)
2. Press SELECT once to clear the keymoved key.You
will see [DELETED] appear in the display, followed by
[EXIT SETUP].The URC-8910 remote control will
automatically exit the programming mode and return
to normal operation.
Restoring All Keymoved Keys In A Single Mode
1. Perform steps 1 through 4 of the earlier section,
Programming Keymover on page 38.However, this
time in steps 3 and 4, make the source mode and
source key the same mode (e.g., TV).You will see the
display change to [CLR KMVR].
2. Press SELECT once to clear all keymoved keys from
this mode.You will see [DELETED] appear in the
display, followed by [EXIT SETUP].The remote control
will automatically exit the programming mode and
return to normal operation.
27
To Next Page
Loading...
