USING THE HOME THEATER MODE
Programming The Home Theater Mode
5. (continued)
a. Select a device for Channel Control Group assign-
ment. For this example, press CBL once. This will
assign the entire group of Channel Controls (i.e.,
CH+, CH-, (Keypad) 0 ~ 9, ENTER, LAST,
SLEEP, INFO,and TV/VID) to the cable converter.
You will see the display change to your device
choice (e.g., [CBL]).
b. Press SELECT once to accept the assignment in
step 5b.You will see the display change to the next
Control Group assignment, [MENU]).
6. Press SELECT once to enter Menu Control Group
assignment.You will see the display change to the
last-selected device (e.g., [CBL]).
a. Select a device for Menu Control Group assignment.
For this example,press CBL once. This will assign
the entire group of Menu Controls (i.e., MENU,
GUIDE, Cursor Controls (▲,▼,,),SELECT,and
EXIT) to the cable converter.You will see the display
change to your device choice (e.g.,[CBL]).
b. Press SELECT once to accept the assignment in
step 6a.You will see the display change to the next
Control Group assignment, [PIP]).
7. Press SELECT once to enter PIP Control Group
assignment.You will see the display change to the
last-selected device (e.g., [CBL]).
a. Select a device for PIP Control Group assignment.
For this example, press TV once.This will assign
the entire group of PIP Controls (i.e., PIP, MOVE,
and SWAP) to the TV.You will see the display
change to your device choice (e.g., [TV]).
▲
▲
33
To Next Page
Loading...
