OneTouch Select - Page 10

7
SETTING UP YOUR METER
 CAUTION: Matching the code on the meter and the code on the test strip vial is essential to obtaining accurate results.
Each time you test, check to make sure the code numbers match.

Match the code on the meter with the code on the test strip vial
If the code on the meter does not match the code on the test strip vial, press
or
to
match the code number on the test strip vial. The new code number will ash on the display
for three seconds, then briey stop ashing, after which the display will advance to the
APPLY SAMPLE screen.
If the codes already match, press to go to the APPLY SAMPLE screen. When you do not
make a change after ve seconds, the display will advance to the APPLY SAMPLE screen.
The meter is now ready to perform a blood glucose test.
NOTE:
• If the APPLY SAMPLE screen appears before you are sure the codes match, remove the test strip, and re-start from step 1.
• If you change APPLY SAMPLE to APPLY CONTROL by mistake, press
to change it back to APPLY SAMPLE.
APPLY SAMPLE
▲