6
SETTING UP YOUR METER
Coding your meter
Check the code on the test strip vial before inserting the test strip
Code numbers are used to calibrate your meter with the test strips you are using.
Insert a test strip to turn on the meter
Remove a test strip from its vial and recap the vial immediately. With clean, dry hands, you may touch the
test strip anywhere on its surface. Do Not bend, cut or modify the test strips in any way. Use each test strip
immediately after removing it from the vial. Insert the test strip into the test port as shown. Make sure the
three contact bars are facing you and the arrow is pointing down. Push the test strip in as far as it will go.
After the black start-up screen appears, the meter will display the code from your last test.
If a ashing “– –” appears instead of a code number, such as when you are rst using the meter,
follow the instructions in Step 3 to change to a numerical code.
MATCH CODE
25
To Next Page
Loading...
