3
GETTING TO KNOW YOUR SYSTEM
Turning your meter on
There are two ways to turn your meter on:
To perform a test, insert a test strip as far as it will go. The meter will briey
perform system checks, then the display will turn on.
or,
With the meter turned o, press and hold for two seconds to access
MAIN MENU.
Check that the screen shows solid black for two seconds. If it does, the display is working properly. If the meter does not
power on, try changing the meter battery. See Replacing the battery in Section 7.
Turning your meter o
There are several ways to turn your meter o:
• Press and hold
for three seconds.
• Your meter will turn o by itself if left alone for two minutes.
• Go to MAIN MENU and press
or
to highlight METER OFF, then press .
• Before or after completing a test, remove the test strip. If you advance from the test result screen to the MAIN MENU by
pressing , removing the test strip will not turn the meter o. Use one of the three methods above.
CAUTION: If you see any light areas
within the black start-up screen, there
may be a problem with the meter. Call
Customer Service.
To Next Page
Loading...
