OneTouch Select - Page 46

40
3. Match the code on the meter with the code
on the test strip vial
If the code on the meter does not match the
code on the test strip vial, press or to
match the code number on the test strip vial.
The new code number will flash on the display
for three seconds, then briefly stop flashing,
after which the display will advance to the APPLY
SAMPLE
screen.
If the codes already match, press to go to the
APPLY SAMPLE screen. When you do not make a
change after five seconds, the display will
advance to the APPLY SAMPLE screen.
4. Mark the test as a control solution test
Press to change APPLY SAMPLE to APPLY
CONTROL
. You must mark the test before you
apply control solution. Once you have completed
the test, you cannot change the marking.
The meter is now ready to perform a control
solution test.
Control solution testing