OneTouch Verio Flex - Page 85

83
7
Battery
Replacing the battery
Your OneTouchVerioFlex™ Meter uses one CR2032 lithium
coin cell battery.
IMPORTANT: Use only one CR2032 lithium coin cell battery
with your meter. Do Not use rechargeable batteries. Use
of an incorrect battery type may result in your meter
providing fewer tests than normal.
If the meter does not turn on, you may need to replace the
battery. See below for instructions.
WARNING: Certain batteries may cause leaking which can
damage the meter or cause the battery to lose power sooner
than normal. Replace leaking battery immediately.
Pull up on the battery ribbon
to lift the battery out of the
compartment.
Do Not remove the battery while
the meter is connected to a
computer.
2. Insert the new battery
Insert one CR2032 lithium coin
cell battery on top of the battery
ribbon, with the plus (+) side up.
If the meter does not power on after you have replaced the
meter battery, check that the battery is correctly installed.
If the meter still does not power on, contact OneTouch®
Customer Care on 0800121200 (UK) or 1800535 676
(Ireland).