4
Model Data
The operator must be provided with the owner’s manual. This must be read
before operation and followed during operation.
These instructions are a guide only. Users not familiar with pool equipment
should seek advice for suitably qualied persons with experience in pool
equipment installation.
Manufactured in Australia, the Onga Pantera II sand lter is made from
UV stabilised polyethylene. The reputation of durability and performance
makes the PanteraII range rst choice for quality pool builders.
Technical Data
P221 P225 P229 P233
Filter Diameter (mm) 535 635 735 835
Filter Area (m
2
) (Internal) 0.205 0.293 0.397 0.517
Max Working Pressure (kPa) 280 280 280 280
Maximum Flow Rate (lpm) 165 235 320 415
Design Flow Rate (lpm) 145 205 280 365
Min Flow Rate for Backwashing (lpm) 125 175 240 310
Recommended Pool Volume (litres):
Minimum 30000 45000 60000 75000
Maximum 65000 90000 120000 160000
Filter Height (to top of valve)* 840 960 1090 1170
Required mass of lter media:
Sand (16/30 grade) (kg) 90 140 185 220
Zeolite (kg) 70 105 140 165
Valve Size (connection to PVC) (mm) 40 40 50 50
*It is recommended to ensure there is at least 600mm of clear space above
the top of the lter to facilitate servicing.
Due to excessive cycling, this lter is not suitable for
use on inbuilt In-oor Cleaning Systems.
To Next Page
Loading...
Need help?
General