How to troubleshoot no signal on Onicon F-1100?
To troubleshoot a 'no signal' issue with your Onicon Measuring Instruments, start by verifying that the meter is inserted correctly into the pipe and that the electronics enclosure is parallel with the pipe. Next, check the 24 V supply voltage and ensure correct wiring to the control system, referring to the wiring diagram. Finally, inspect the turbines for any debris.
What to do if analog signal is incorrect on Onicon F-1100?
If the analog signal on your Onicon Measuring Instruments seems high or low and does not correspond to the frequency output, check for a ground loop or offset voltage. Disconnect the analog signal input to the control system and measure the analog outputs directly from the flow meter. Re-connect the signal input to the control system and measure the analog signals again. Any difference between these readings indicates a potential ground loop or offset voltage.
Why is the reading too high on my Onicon Measuring Instruments?
If the reading on your Onicon Measuring Instruments is too high, it could be due to several factors. First, ensure there is adequate straight pipe run upstream of the meter. Verify the pipe size and contact the factory if it differs from the calibration tag. Also, check that the meter is inserted correctly into the pipe and that the electronics enclosure is parallel with the pipe. Confirm the wiring to the control system is correct and that output signals agree. Ensure the control system is programmed for the correct flow range or scale factor, and inspect the turbines for debris.
Why no flow rate on Onicon display module, but control system displays it?
If your control system displays the flow rate, but there is no flow rate indication on the local display module or BTU Meter for your Onicon Measuring Instruments, verify that all wires from the flow meter were connected to the display module or BTU meter. Specifically, ensure that the frequency output wire (green) is connected, as it is essential for any ONICON display or BTU meter to function correctly.
General safety precautions to observe during installation, operation, and repair.
Explanation of symbols like WARNING, CAUTION, and IMPORTANT NOTE.
Provides specific information for installation, operation, and maintenance of turbine flow meters.
Explains how turbine meters measure fluid velocity using turbine rotation and frequency.
Details accuracy, sensing methods, pipe sizes, temperature, pressure, and materials.
Explains meter model codes, serial numbers, and warranty details.
Ensures all documentation and meter parts are present and undamaged.
Guidance on choosing accessible locations with adequate straight pipe runs.
Specifies minimum straight pipe lengths for F-1100, F-1200, FB-1200 series.
Specifies minimum straight pipe lengths for inline meters.
Details installing the meter through an isolation valve assembly.
Procedure for inserting the meter using a depth gauge or manual method.
Step-by-step process for safe removal of the meter under pressure.
Instructions for connecting the flow meter's output signals to display or control systems.
Helpful hints for ensuring proper meter setup and calibration.
Step-by-step guide for verifying insertion meter installation and output signals.
Steps for verifying inline meter installation and output signals.
Solutions for problems like no signal, incorrect readings, or wiring errors.
Explains analog output calibration and when adjustments might be needed.
Detailed steps for recalibrating analog output signals using test equipment.
Diagrams showing user connections and internal wiring for various meter models.
Guides for installing specific hardware kits for different pipe types and methods.
Diagrams illustrating the assembly and maintenance of turbine rotors and bearings.
Details ONICON's warranty, delivery, pricing, and legal terms for product sales.
General| Brand | Onicon |
|---|---|
| Model | F-1100 Series |
| Category | Measuring Instruments |
| Language | English |
To Next Page
