Onicon F-1210 Owner's Manual

Owner’s Manual for ONICON Insertion Turbine Flow Meters • September 27, 2001
17
4.3 START-UP AND COMMISSIONING WORKSHEET
Please read all installation instructions carefully prior to proceeding with these steps. Wiring
diagrams are located in the appendix. Use the following worksheet for checking off the
commissioning steps and recording measured values:
STEP
TEST / MEASUREMENT
S/N: 1
S/N: 1 S/N: 1 S/N: 1
1.
Meter location
# # # #
2.
Confirm pipe size
# 1
# 1 # 1 # 1
3.
Insertion depth and orientation
# # # #
4.
Control system programming
# # # #
5.
Match display or BTU meter
serial#(if ordered)
# 1
# 1 # 1 # 1
6.
Signal Connections Verified
# # # #
7.
Supply voltage verified
# 1
# 1 # 1 # 1
8.
Connect power
# # # #
The following steps require flow in the pipe. Flow signal readings should be taken while holding the flow rate constant if possible,
otherwise, take the various output readings as quickly as possible.
9.
Frequency output(s):
Avg = green, Top = white
Bottom = orange
Avg Freq. (HZ):
Avg Freq. (VDC):
Top Turbine (HZ):
Top Turbine (VDC):
Bottom Turbine (HZ):
Bottom Turbine (VDC):
Calculated Flow Rate:
Hz
VDC
Hz
VDC
Hz
VDC
GPM
Hz
VDC
Hz
VDC
Hz
VDC
GPM
Hz
VDC
Hz
VDC
Hz
VDC
GPM
Hz
VDC
Hz
VDC
Hz
VDC
GPM
10.
Analog or binary outputs
4-20 mA signal:
0-10 V signal:
Scaled output interval or
divided output frequency
Calculated Flow Rate:
MA
VDC
1
GPM
MA
VDC
1
GPM
MA
VDC
1
GPM
MA
VDC
1
GPM
11.
Flow rate displayed by control
system
GPM GPM GPM GPM

Onicon F-1210 Specifications

General

Brand	Onicon
Model	F-1210
Category	Measuring Instruments
Language	English