11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax +1 (727) 442-5699 • sales@onicon.com
F-3100 Flow Meter Manual 11/17 - 0670-9 Page 29
Step 1: Loosen screws to lift cover. Step 2: Lift cover to expose electrical connections.
Step 3: Make SIGNAL connections as shown
Pull straight out on connectors to remove them.
Step 4: Open cover to expose POWER connections.
+24V INTERNAL
24V COMMON
4-20mA OUT
9 (+)
10 (-)
mA
• Opto-coupled output
• Maximum load: 1000Ω
• Internally Powered Loop
• Maximum voltage without load: 27V
• Refresh frequency is the same of the sample
frequency of the the connected sensor body
• Protected against persistent over voltages to
maximum 30V
4-20 mA OUTPUT
To Next Page
Loading...
