Onicon F-3100 Series - Default Chapter; Table of Contents

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax +1 (727) 442-5699 • sales@onicon.com
F-3100 Flow Meter Manual 11/17 - 0670-9 Page 5
TABLE OF CONTENTS
1.0 INTRODUCTION .................................................................................................7
1.1 Purpose Of This Guide ............................................................................. 7
1.2 Principle Of Operation ............................................................................. 7
1.3 Typical Flow Meter Installation ............................................................... 7
1.4 Standard Features And Specications ..................................................... 8
1.5 Additional Hardware That May Be Required ........................................... 9
1.5.1 Grounding Rings ..........................................................................9
1.5.2 Gaskets .......................................................................................10
1.6 Working Environment ............................................................................10
1.7 Warranty And Serial Number .................................................................10
2.0 UNPACKING ....................................................................................................11
2.1 Checking That You Have Received Everything ..................................... 11
3.0 INSTALLATION ................................................................................................. 12
3.1 Site Selection ..........................................................................................12
3.1.1 General Guidelines ....................................................................13
3.1.2 Flow Direction ...........................................................................13
3.1.3 Remote Mount Transmitter .......................................................13
3.1.4 Minimum Straight Run Requirements ...................................... 14
3.2 Mechanical Installation ..........................................................................15
3.2.1 Standard Transmitter Dimensions ............................................15
3.2.2 Sensor Body Dimensions & Weights .........................................16
3.2.3 Installation Drawing For Conductive Pipe ...............................19
3.2.4 Installation Drawing For Non Conductive Pipe .......................21
3.2.5 Installation Drawing For Threaded Connections .................... 22
3.2.6 Installation Instructions .......................................................... 23
3.2.7 Torque Specications ...............................................................25
3.2.8 Remote Mount Transmitter .......................................................26
3.3 Electrical Installation ..............................................................................27
3.3.1 Input Power Requirements ........................................................ 27
3.3.2 Power And Output Signal Wiring Instructions ........................27
3.3.3 Earth Connection .......................................................................30
3.3.4 Remote Mount Cable Wiring Instructions ................................31