Onkyo A-8017 - Page 3

A 8017
PRECAUTIONS
1, Replacing the fuse
For continued protection against risk fire, replace only
with same type and same rating fuse.
DESCRIPTION
6A(ST-6), AC fuse (120V model)
6A-T, AC fuse (120V/220V
model)
3.15A-SE-EAK, AC fuse
(220V, 120V/220V model)
1A-SE-EAK, AC fuse
(220V model)
6.3A-SE-EAK, DC fuse
—(220V model)
CIRCUIT NO. PARTS NO.
F901 252051
F901 252055
F902 252076
F701 252070
F1, F2 252079
. Replacing the lamps
This unit uses the lamps listed below.
PARTS NO.
210153
CIRCUIT NO.
PLOO1, PLOO2
PL301, PL302 210155
PL303 210150
PL304, PL30S 210146
PL306, PL307 9210147
PL701 210148
PL702 210151
DESCRIPTION
PL14V, 0.06AW-1.0,
Speaker switch indicator
PLI4V, 0.06AW-1.0,
Rec. selector indicator
PLI4V, 0.08AW-1.0,
Input selector indicator, Phono
PL14V, 0.06AW-1.0, Input
selector indicator, DAD/AUX
PL14V, 0.06AW-1.0, Input
selector indicator, TAPE
PLI4V, 0.06AW-1.5,
Power indicator
PLI4V, 0.08AW-1.5,
Servo indicator
MAIN AMPLIFIER ADJUSTMENT
Standard knob position
INPUT SELECTOR
CARTRIDGE SELECTOR
PHONO SELECTOR
REC SELECTOR
MODE
MUTING
SUBSONIC FILTER
BALANCE
VOLUME
LOUDNESS
BASS
TREBLE
SPEAKERS
MAIN AMPLIFIER ADJUSTMENT
Set the all control knobs to standard position
TUNER
MM
PHONO
OFF
NORM
OFF
OFF
Center
Minimum
OFF
DEFEAT
DEFEAT
A
3. Insulation resistance mesurement
Connect the insulating-resistance tester between the plug
of power supply cable and the terminal GND specifica-
tions; D model, G/W model
. Voltage selector (rear panel)
Worldwide models are equipped with a voltage selector
to conform with local power supplies. Be sure to set this
switch to match the voltage of the power supply in your
area before turning the power switch on. Voltage is
changed by sliding the groove in the switch with a scre-
wdriver or similar instrument to the up or down position.
Confirm that the switch has been moved all the way to
the up or down before turning the power switch on. If
there is no voltage selector switch on the unit you have
purchased, it can only be used in areas where the power
supply voltage is the same as that of the unit.
220V~ 220V~
at AC 220V g at AC 120V
120V~ 120V~
IDLING CURRENT ADJUSTMENT
1. Connect the DC voltmeter between Ipyp and Ver
terminals.
2. Adjust the voltage to 12V+5mV with semi-fixed resistor
of R538 and R638.
NOTES: Adjust after switching on for 5 minutes.
WOLUME. cia ie co ohve vey eee Minimum
LOAD 3536 ab ais pS Waa ROHS Open