Onkyo A-R700

{2 Balance Control Knob (BALANCE)
Adjust to control the relative volume level of the left and right
speakers or headphones.
{3 Source Direct Switch (SOURCE DIRECT)
TONE : The DIRECT TONE control, MUTING (—20dB),
BALANCE and MODE of the performance can be
altered for the source selected with the INPUT SE-
LECTOR button, or remote contro! transmitter.
DIRECT : The volume of the source selected with the INPUT
SELECTOR buttons or remote contro! transmitter
can be input directly into the main amplifier. At this (15)
time the signa! will bypass the DIRECT TONE,
MUTING (-20dB), BALANCE, and MODE circuits.
MONITOR TAPE-1/TAPE-2
: The sound which is being recorded can be moni-
tored, when the three-head tape deck is connected.
When this is selected, DIRECT TONE, MUTING
(~20dB), BALANCE, and MODE can be effective.
Recording Source Selector Switch (REC SELECTOR)
DAT or TAPE can be selected by the REC SELECTOR switch.
TAPE-1 ® DAT & TAPE-2 / DAT TAPE-1 & 2
: Use either of these settings for tape dubbing oper-
OFF
SOURCE:
ations depending on which deck is being used for
playback and which is being used for recording. For
details, refer to the Operations section.
: When not recording or dubbing.
Recording from the source selected by the INPUT
SELECTOR buttons or remote contro! transmitter.
Cartridge Selector Switch (CARTRIDGE)
MC SUBSONIC : Turntable using an MC cartridge with
MC
MM
subsonic filter.
: Turntable using an MC cartridge.
: Turntable using an MM cartridge.
MM SUBSONIC : Turntable using an MM cartridge with
subsonic filter.
Use the MM position when a step-up transformer is being used
with a turntable equipped with an MC cartridge.
Remote control transmitter RC-180S
Power Button (POWER)
Input Selector Buttons (TAPE-2, TAPE-1,
TUNER, CD, DAT, AUX-2, AUX-1,
PHONO)
CD Operation Buttons (CD)
These buttons are used to operate an ONKYO
CD piayer with the FRI mark.
a. : Press this button to pause the CD
play back. To resume disc play,
press the PLAY ( ® ) button.
p> : Press this button to play the CD
player.
@ : Press this button to stop the CD
player.
iq: Press this button to go back to the
beginning of the current track and
again to skip back to the previous
track.
bP} : Press this button to skip to the next
track.
cI
INPUT SELECTOR ——————
TAPE-2 TAPE TUNER
cI Ca
PHONO
AUX- AUK-T
Ca Co
DAT
co
ONKYO ac-ie0s
REMOTE CONTROL TRANSMITTER
RI
Tuner Operation Buttons (TUNER)
<@ PRESET » : Preset memory DOWN/UP
buttons
Tape Operation Buttons
({DECK-A, DECK-B)
These buttons contro! ONKYO double cassette
tape decks that can be remote controlled. Use
the DECK-B buttons to control single cassette
tape decks with the FRI mark.
<4: The tape plays, moving from right
to left, or, in the recording stand-by
mode, recording begins.
p> : The tape plays, moving from left to
right, or, in the recording stand-by
mode, recording begins.
e/a : When this is pressed, the recording
stand-by mode is entered.
m@ -: Interrupts all operations.
<<: Fast forward from right to left.
>> : Fast forward from left to right.
Audio Muting Button (MUTING —~°)
This button temporarily switches off the sound
from the speaker or headphone. Pressing this
button will operate the A-R700 audio muting
circuit. The audio muting indicator will blink
on and off. Pressing the button again or using
the POWER button to turn the power on will
turn off the audio muting.
ees Volume Buttons (_ 4 UP, | DOWN)
PRINTED CIRCUIT BOARD VIEW FROM
NAAF-3901
meflen—
__O@Ir
és ofp
tele
Tir vor ©
NASW-3902
€92r
ower eh meee
ome OER
BOTTOM SIDE
—21—-—
—~22—