Onkyo ABX-100 - Setting the Clock

En-11
Setting the Clock (by remote controller only)
Note:
• Clock settings can be made only while the ABX-100
is in standby mode. If the ABX-100 is powered-on,
press the [] button to put the unit in standby mode.
1
Press the [TIMER] button.
2
Use the []/[] buttons to select “Clock
Setup”.
3
Press the [ENTER] button.
4
Use the []/[] buttons to enter the current
time.
Hold down the buttons to change the value quickly.
Tip:
• To change the time format between 12-hour and 24-
hour, press the [DISPLAY] button.
5
Press the [ENTER] button.
A pixel in the lower right will blink to indicate that
the clock has started.
6
Use the []/[] buttons to select the day of
the week.
7
Press the [ENTER] button.
Tip:
• If you press the Display button while in standby mode,
the time and date will be displayed for eight seconds.
ENTER
MENU
TIMER
M
F, H
DISPLAY
Timer1 Setup
Timer2 Setup
Clock Setup
Clock Setup
12:09
Friday
Clock Setup
12:09
Friday