Onkyo BD-SP807

48
FUNCTION SETUP
EN
*) Settings with (*) are the default.
• HDMI CEC allows integrated system control over HDMI and is part of the HDMI standard.
In addition to Onkyo AV components, it allows interoperability with CEC-compatible AV components and TVs made by
other manufacturers.
• When “HDMI CEC” setting is set to “On”, functions listed below will be available.
Direct Change
When this unit is turned on, the TV is also turned on and the appropriate external input channel will be selected
automatically. The appropriate external input channel can also be selected on your TV automatically when you press
[PLAY B] when the unit’s power is on.
Standby
When you press and hold [I /Q ON/STANDBY] on the front panel for 2 seconds, it turns off the power of the TV first
and then turns off the power of this unit also.
System Information
Get & Set Menu Language
• The unit recognises the OSD language set for the TV and automatically sets the same language as the player menu
language (OSD menu language) for this unit.
• This feature is available only when “Auto(XXXX)” is selected in “Player Menu” in the setup menu. (Refer to “Player Menu”
on page 38.)
Setting items Options
Network Connection Connection Test Perform the network connection
test. After you change the IP
address or DNS setting, always
perform this test.
Enable(Easy)* If you select “Enable(Easy)”,
Connection test will
automatically start.
Enable(Custom) IP Address
Setting
Auto(DHCP)* Set the IP address.
In most cases, you can connect
to the Internet without making
any changes to the default
setting.
Manual IP Address
Subnet
Mask
Default
Gateway
DNS Setting Auto(DHCP)* Set the DNS setting.
In most cases, you can connect
to the Internet without making
any changes to the default
setting.
Manual Primary
DNS
Secondary
DNS
Proxy
Setting
Do Not Use* Set the proxy server.
In most cases, you can connect
to the Internet without using
proxy server.
Use Proxy
Address
Proxy Port
Connection
Speed
Auto* Set the connection speed.
In most cases, you can connect
to the Internet without making
any changes to the default
setting.
10BASE Half
10BASE Full
100BASE Half
100BASE Full
BD-Live
Setting
Allow* You can restrict Internet access
Limited Allow when BD-Live
functions are used.
Limited Allow
Prohibit
Disable Deactivate the network
connection.
Software Upgrade
Allows you to upgrade this
unit’s firmware.
Refer to page 52.
Current Version :
Indicates the current firmware version.
Disc Upgrade :
Allows you upgrade this unit’s firmware using a disc.
Network Upgrade :
You can upgrade the firmware version by connecting this unit to the Internet.
Note
• HDMI CEC is available only when the display device is connected by an HDMI cable, and when it supports HDMI CEC
feature.