19
CONNECTIONS
EN
• You can use a disc which offers BD-Live function by connecting the unit to the Internet.
(For BD-Live information, please refer to page 32)
Make sure to connect the telecommunications equipment (modem, etc.) to the ETHERNET terminal via Hub or
broadband router.
After you made all necessary connections, connect the AC cord to the AC INLET. Then connect the AC cord to the AC
outlet.
Insert the plugs securely. Incomplete connections will result in the generation of noise.
Network Connection with LAN
LAN
NALNAW
12345
this unit
Internet
LAN cable
LAN cable
Hub or broadband router
Telecommunications
equipment (modem, etc.)
No supplied cables are used in this connection:
Please purchase the necessary cables at your local store.
Note
• After connecting to the Internet, set up necessary network settings.
• Do not insert any cable other than a LAN cable to the ETHERNET terminal to avoid damaging the unit.
• If your telecommunications equipment (modem, etc.) does not have broadband router functions, connect a
broadband router.
• If your telecommunications equipment (modem, etc.) has broadband router functions, use a hub.
• For a broadband router, use a router which supports 10BASE-T/100BASE-TX.
• Do not connect your PC directly to the ETHERNET terminal of this unit.
• For the network setup, refer to “Network Connection” on pages 49-52.
• For more information about cables or connections, see the manual accompanying modem, broadband router and
hub you use.
Connecting the AC Cord
Supplied cables used in this connection are as follows:
• AC cord x 1
AC cord
AC110-240V, 50/60 Hz
this unit
AC outlet
To Next Page
Loading...
