EasyManuals Logo

Onkyo CS-265 User Manual

Onkyo CS-265
256 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
En-34
Troubleshooting—Continued
Reception is noisy, stereo FM reception suffers from hiss, the Auto Preset function doesn’t preset
all stations, or the FM ST indicator doesn’t light up when tuned to a stereo FM station.
Check the antenna connections (see page 14).
Change the position of the antenna (see page 14).
Move the CD receiver away from a nearby TV or computer.
Cars or airplanes can cause noisy interference.
The radio signal will be weakened if it has to pass through a concrete wall before reaching the antenna.
Switch to Mono mode and listen in mono. The FM ST indicator will go off (see page 26).
If none of the above improves the reception, install an outdoor antenna (see page 14).
Can’t adjust the frequency of the radio.
Use the remote controller’s [
e
TUNING]/[TUNING
r
] buttons to change the frequency of the radio (see page 26).
RDS information doesn’t appear.
The FM station you are tuned to doesn’t support RDS.
The radio signal is weak. Change the position of the antenna. If the situation does not improve, install an outdoor
FM antenna (see page 14).
No sound is heard from your turntable.
Make sure the turntable has a built-in phono equalizer. If the turntable doesn’t have a phono equalizer built-in,
you must provide one.
The timer doesn’t work.
Make sure the clock has been set correctly (see page 29).
Timed operation will fail if the CD receiver is on at the specified On time, so make sure it’s set to Standby (see
page 30).
If a power failure occurs and the clock stops, the timer will be disabled. Reset the clock, and then enable Timer
as you desire.
The display indicates “- - : - -” when you press the [CLOCK CALL] button.
A power failure has occurred, and the clock has stopped. Set the clock again (see page 29).
Standby power consumption.
Charging will begin when you connect an iPod/iPhone/iPad, causing the power consumption to increase.
Charging will occur even if the CD receiver enters standby mode.
Tuner
External Components
Timer
Clock
Others
Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the unit’s
malfunction. Before you record important data, make sure that the material will be recorded correctly.
The CD receiver contains a microcomputer. In very rare situations, severe interference, noise from an external
source, or static electricity may cause it to malfunction or lock up. In the unlikely event that this should happen,
unplug the power cord, wait at least 5 minutes, and then plug it back in again. If this doesn’t resolve the issue,
reset the CD receiver to its factory defaults (see page 31).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Onkyo CS-265 and is the answer not in the manual?

Onkyo CS-265 Specifications

General IconGeneral
TypeHome audio mini system
Cassette deckNo
Product colorWhite
Optical disc playerYes
Karaoke-
Impedance6 Ω
Speaker type2-way
Frequency range30 - 22000 Hz
RMS rated power40 W
Woofer diameter100 mm
Tweeter diameter20 mm
Number of speakers2
Signal-to-Noise Ratio (SNR)77 dB
Total Harmonic Distortion (THD)0.1 %
FM band range87.5 - 108 MHz
Supported radio bandsFM
Preset stations quantity30
Display typeLCD
Bluetooth version4.0
Power sourceAC
Input voltage220-240 V
Input frequency50 - 60 Hz
Power consumption (standby)0.4 W
Power consumption (typical)32 W
Weight and Dimensions IconWeight and Dimensions
Depth176 mm
Width130 mm
Height210 mm
Weight1700 g
Package depth281 mm
Package width357 mm
Package height406 mm
Package weight6700 g
Main unit weight1900 g
Main unit dimensions (WxDxH)215 x 273 x 99 mm

Related product manuals