Onkyo DR-645

18
En
Basic Operation
Basic Operation
1
Press 9 ON/STANDBY to turn the unit on.
• The unit turns on with the source that was last
selected.
2
Press DVD, iPod/USB, FM, or LINE to select a
source.
The selected source is shown on the front panel’s
display.
Press LINE repeatedly to switch between LINE 1
and LINE 2.
Also, each time INPUT on the unit is pressed, the
source changes as follows:
•DVD Source
•iPod
• USB Source
• FM Radio
• LINE1 Source
• LINE2 Source
3
Play the source, and adjust the volume using
q VOL w.
You can rotate the VOLUME knob on the unit to
reduce or bring up the volume continuously.
•Press 9 ON/STANDBY to put the unit in the
standby mode when it is not being used.
Setting the Clock
1
If the unit is on, press 9 ON/STANDBY to turn
it standby.
2
Press CLOCK to show the time on the display.
• The time appears on the display (if the time is not
set after it blackout, “--:--” blinks). Press CLOCK
again, the “hour” value starts blinking.
• When no button is pressed for 30 seconds, the time
setting mode will be cancelled.
3
Press q VOL w to set the current hour.
4
Press CLOCK.
The “minute” value starts blinking.
5
Press q VOL w to set the current minute.
6
Press CLOCK.
The clock starts.